Thank you for viewing. This is a TJ draft 15-16 model. Size is 156cm, used as a powder board. I only used it on fresh snow and packed snow, and since I also rode other boards, the riding time is quite short. I haven't ridden it in the last few years, so I think it's been ridden for about 20 days in total. After riding, I always applied rust prevention, but I couldn't do maintenance immediately when I got injured, so there are a few spots of rust, and I've applied a rust-stopping liquid to create a black rust condition. The fourth photo shows the location, and the fifth photo shows the area around the rust. There are no other scratches that would cause problems with riding, but there are some light scratches and dents. The deck has contact marks from the lift, and there are also scratches from the ankle ratchet. Since I put a protective plate under the bindings, there are almost no binding marks. Although it's hard to see, I had a sticker under the rear-side screws. I applied wax every year so it's not completely unmaintained. It's only been maintained by an amateur. The sole cover is in good condition as I hardly used it, but there is some light soiling as I sometimes put it on for storage. I mostly stored it folded. I will include the storage case that came with the purchase, but it has dirt and tears. Please purchase with the understanding of the above. My personal impression: It's a powder board, but it can also carve, and the 3D sole provides a comfortable ride. It also has some quirks. You don't have to worry about catching on walls, and it climbs smoothly, making it fun. The nose is soft, so it's easy to do butter tricks, and I think it's a fun board to play with. TJ – Draft Length 1560 Eff Edge 1060 Co Length 1060/Flat 720 Nose 315 Waist 262 Tail 295 Radius(mr) 6.2 Stance 500-580 Setback 65 Core FWTC mix core Sidewall UHMW Base P-tex 4000 Graphite Glass Triaxial Nose Bottom 3 Dimensions Tail Bottom Flat Convex Tail Bottom 3 Dimensions I removed the wax for the photos, but I will reapply solid base wax.