Pera Tire Half Tire Stepped Pera Tire Mini4wd 3D Printed Red This is a jig for easily making Pera tires, etc. Please use an S2 chassis as a work machine. After purchase, please let us know your desired pattern via message: "Handle Version" "Knob Version" *If you do not make a selection within 24 hours of purchase, we will ship the handle version. ◆Contents◆ *See image 1. ・Tire Setter HANDY body (Red) 1 piece ・Cutting bit 30 <for roughing> 1 piece ・Cutting bit 60 <for finishing> 1 piece *The one with the shallower angle is for finishing. ◆How to Use◆ ・Attach the tire setter body to the S2 chassis. ・Attach the wheel tire, which has been glued with adhesive, etc., to the work machine. (For wheels with short axles, use spacers to extend them to the range where the cutting bit can reach.) ・Pass the cutting bit through the hole near image 4 ① from the back, and there is a screw on the left side to secure it, so tighten and fix it at a position where the blade lightly touches the tire. (Make sure the blade part of the cutting bit comes out of the front hole in a "reverse D" shape.) ・Apply cutting oil to the blade of the bit. (If you don't have any, you can substitute with sesame oil, etc.) ・Turn on the work machine's switch and slowly wind the handle (or knob) on the right side of the tire setter. *Do not cut it all at once, but cut it little by little, about 2-3mm in radius. Recovery is possible, but it will be very troublesome. ・Once you reach the desired size, lightly sand the tire and polish the surface of the tire with parts cleaner, etc. Caution ・Please use with extreme caution as you will be using a blade. We are not responsible for injuries caused by the blade due to incorrect use. ・We have checked for a certain degree of strength and durability, but since it is a plastic material, please handle it with care and avoid applying excessive force. #Toreca no Mori #Rabbit_Racing #Jig