【How to Use】 This product is a jig for easily cutting catcher dampers used in Mini 4WD MS Flex and other setups. The following tools are useful for the work (all available at 100-yen shops): • Carving knife (flat chisel, triangular chisel) • Double-sided tape • Hammer • Design knife • Scissors • Drill (for weight reduction holes) Procedure 1. Securely fix the jig and catcher with double-sided tape. 2. Roughly cut with scissors. 3. Along the edge of the jig, lightly tap the flat chisel with a hammer to cut straight. 4. For the corners, align the triangular chisel with the corner and cut with a hammer. 5. Cut out the weight reduction holes as desired. 6. Finally, trim the cut edges with a design knife, and drill holes as needed. 【Disclaimer】 This product is a support tool intended for personal hobby use. The manufacturer assumes no responsibility for any injuries, part damage, or any other damages during the work. Please be sure to take safety precautions and use at your own risk. 【Support】 This product is only a support jig for hobbies. If you are unfamiliar with the work or have any questions about the details, please feel free to contact us via transaction messages after purchase. The manufacturer will provide support as much as possible. ※Instructions are being prepared with sincerity, but are not currently included, so if you need them, we will respond via message. ※Please manage safety and processing results at your own risk. 【Deals】 We offer discounted prices when you purchase this product with other products from our store. Please check the product list or profile for details. Other products are here ↓ #OROBLAM_LAB #Mini4WD #MSFlex #CuttingGuide #FlexProcessing #Mini4WDJig #MSFlexModification #HomemadeJig #3DPrint #CatcherDamperMold #Jig