# Solar Reflective Stickers Brightness > 400 cd/(lx/㎡) Very bright. Material: PES low elasticity (so it's not a highly elastic fabric for a very good fit) Ironing temperature: 140 ~160 ℃, wait for the tape to cool down, then peel off the plastic protective film. Recommended as it gets dark early in the winter. I'm selling it because I didn't use it all. Reflective material for peace of mind on night roads Notes As shown in the photo, this heat transfer film is not suitable for nylon or any other water-repellent substrates. This heat transfer film is not suitable for mesh fabric holes; heat film on holes without a substrate has low adhesion strength and is easily damaged during the cleaning process or daily use. For lamination temperature, time, speed, and pressure, we must use the guide. For all fabrics, we recommend that the substrate is always tested before production to ensure they meet your specific needs and to ensure sufficient adhesion and physical performance. After heating, allow the heat transfer film to cool to room temperature, remove the reflective liner by lifting one corner, and pull it off in a continuous, smooth manner. Do not exceed the lamination temperature above. Heat at 140℃～160℃, press for 8 - 20 seconds If you can't peel off the vinyl, the temperature is not high enough. Add heat and repeat ironing How to apply Place the reflective side down on the fabric you want to adhere to. Set the iron to medium heat, place a pressing cloth (100% cotton) in between, and press down. Do not slide the iron; press firmly for about 15 seconds. [Materials that can be applied] Materials that can be ironed at medium heat. Materials with uneven surfaces are more likely to peel off. #Stickers #Nighttime #ReflectiveMaterial #Safety #ReflectiveSticker #Iron #PawPrint #ReflectiveTape #Kindergarten #Students #NightShift #Fluorescent #Handmade