Honda Rebel 250 grab bar. ✳️Installation: Remove the tail lamp etc. as shown in the image, and install it by passing it through from the rear side. Please be careful. (It is designed to be attached to the fender stay) ✴️13mm round bar is used. ✴️Although it is quite strong, please use it within the bounds of common sense. ✴️Please use it at your own risk. ✳️ For confirmation, it has been installed on the fender once. Therefore, there are lacquer paint chips due to interference with the screw parts. ✳️The paint is a simple lacquer paint, and it may be scratched or chipped during transportation. ☪️This is a hobbyist's work. Please understand that there may be distortions, scratches, and slight asymmetry due to hand bending before purchasing.