This is a tool for bending soft metal sheets such as gold, silver, copper, brass, and aluminum. ・Includes a simple Japanese instruction manual. ・Imported product. Minor scratches may be present. ・The main body is made of resin (ABS). ・When using, firmly secure it to a base or clamp it in a vise using the included vise adapter. <Types of Bends> φ12mm, 14mm, 16mm, 20mm, 22mm, 90°, 45° The width of the workpiece is up to 20mm. <Precautions for Use> When processing, place the material on a flat surface. Processing at a high position will cause the roller to recede, and the bend will not be successful, which may also damage the main body. ※Test piece bending results at our company Samples ・Silver, 1mm thick, 10mm wide (annealed) ・Brass, 1mm thick, 10mm wide (annealed) ・Brass round bar φ3mm (annealed) ・Stainless steel, 1mm thick, 10mm wide (annealed) ◎Results 　・Round Bending 　　All samples can be processed without difficulty. 　・Angle Bending 　　　<90° Angle Bending> 　　　Silver and brass could be processed without any problems. 　　　Stainless steel seems to be difficult. 　　　<45° Angle Bending> 　　　All samples could not be processed. 　　　It is thought that processing is possible if the thickness is about 0.5mm. ◎Impressions on Durability 　　・Within the range where processing can be done without applying much force, such as the round bending mentioned above, sufficient durability is considered to be present. 　　・Durability cannot be guaranteed for processing that requires so much force that the roller recedes during processing. 　　 Also, do not perform processing that requires so much force that the roller recedes during processing.