fieldearth Field Earth artride 3D 159 Includes original sole cover Used from purchase, only when there was over 30cm of fresh snow. The short contact length and 3D shape provide ample float in powder. In January 2025, a full tune-up was performed at a tune-up shop near Kanetsu Nerima for approximately 14,000 yen. It has not been used since the tune-up. Hot wax has been applied to the sole, but there are no scratches. Includes the Field Earth original sole cover. Length 1590mm Nose width 304mm Waist width 254mm Tail width 289mm Cam 1.5mm Ef.Edge 1158.2mm C.Length 764mm Sidecut 5800mm Stance 490-570mm The following is from the manufacturer's website: The ARTRIDE 3D is designed with a focus on pop and quickness, incorporating freestyle elements. Special fiberglass that generates rebound while remaining smooth enables ollies and quick edge control. In addition, the short contact length makes it easy to handle, and the 3D shape designed throughout the board, unique to FIELD EARTH, also provides high-speed stability. This is an art ride model that combines both freestyle and freeriding, suitable for art riding on the snow-covered mountains, smoother and more pop-like, both in powder and on groomed snow. Aesthetically, the Artride 3D is stunning and overwhelming in both shape and performance. For many who have never tried or seen a 3D board, the uneven shape of the nose and tail may give the impression that it is difficult to control on-piste or on hard-packed snow. However, this is not actually the case. The three-dimensional shape provides a very dynamic 3D turning ability, as if a ball rolls in any direction from the nose to the edge.