(Stainless Steel Rod Holder) Planned and Produced by FC heian The main image is the item for sale. Cube-kun Short, Integrated Rod Keeper Reinforced with good balance, it's small but powerful. Assembled entirely with stainless steel and stainless steel bolts, featuring a 12Φ stainless steel shaft for double the strength, resulting in ultra-high strength. When clamped with a vise, it can be fixed to car stoppers, handrails, blocks, coolers, etc. Compatible with Snow Peak and trigger-type rod keepers, it fits all rods and can be used immediately. I stood on the rod holder with a 60kg person, and there were no particular problems. If you use the anchors installed on the rocky shore, you can install it without a drill, with just one bolt. Also, it can be fixed to rafts and aquaculture shelves using two 8Φ holes. (Please secure with wood screws) From the rod keeper to the rod rest is approximately 180mm. The stop holes correspond to M8 to M12 anchors. Also compatible with inch screws 3/8, 1/2, and anchors. All are tightened with stainless steel bolts, with no welding points, so there is no risk of breakage. Angle adjustment is possible at the bottom with a bolt. As shown in the image, it can be used at a steep angle by inserting a suitable stone. Buffer material: 6mm thick rubber sheet Total length: approximately 330mm Width: 50mm Weight: approximately 1250 grams Scratches may occur during production or testing. Please bid with your understanding. #Moroko #Tsurimusha #Rod Stand #Shoei #Belmont #Gyro Piton #T-pro #Light Grouper #Ishidai Rod #Ishidai #Kuchibiro #Isoduri (Rock Fishing) #Chinu #Ika (Squid) Rod Keeper Ishizuki (Butt)