Compatible Vehicle Manufacturers: Toyota, specifically for the new Sienta! Type of Parts: Both side molding emblems & rear & front emblems Material: Acrylic resin (Mint Green) This is a side molding accessory specifically for the new Toyota Sienta. It is a self-made product using laser processing. It is a dress-up part that is attached with strong double-sided tape on top of the recessed area of the Sienta logo on the side moldings of the new Sienta. There are many Roman letter logo products from other companies, but most of them are just stickers... This product uses acrylic resin, so there's no risk of air bubbles getting trapped after application like with cutting sheets! Page 2 shows an actual installation image. Note: The installation image is a different color than the product being sold! Installation method: Strong double-sided tape is applied to the back of the Roman letter plate. It can be easily installed by simply fitting it into the logo area under the side molding of the car body. It is important to thoroughly wipe off any dirt from the installation area before installation! On my own car, there have been no problems such as falling off or damage from the installation in February 2023 until now! This is a self-made product, so please understand this before purchasing. There may be some blackening on the edges due to laser processing, and some slight unevenness in the cut-out areas of the letters. Negotiations for price reduction for this product are not accepted! m(__)m Also, we are not responsible for any damage to your car caused by the installation of this product. m(_ _)m