Masking plates (stencils) for reproducing the tire lettering (tire logos) of a radio-controlled car using paint. The inner diameter of the letters is approximately 40mm, and the plate thickness is 0.5mm. Please check the diameter of your wheels. Dimensions have been confirmed with Tamiya F103 and ZEN wheels. Front and rear compatible, set of 2, with fixing attachments. Use by placing it over the tire while the tire is mounted on the wheel. The key is to minimize the gap between the tire and the stencil. Mask as shown in the photo and then spray paint. If the paint doesn't adhere well, use a primer such as Mitzukuron. It is recommended to do a test painting to get used to it. You can paint on masking tape attached to the tire, or paint the back of the tire (the side facing the car body) first. Use a spray can warmed in warm water, spray lightly from a distance, and repeat drying 3-4 times, aiming for a slightly thin finish. For yellow, it is better to paint white first. (Caution) Due to the low heat resistance of the material (PLA resin), do not leave it in a car in the hot summer. It may deform. Avoid soaking in thinner or paint remover. Also, it may deteriorate due to ultraviolet rays and aging. Please note that there may be minor differences from the real car's lettering. (Information) If you wish to purchase this item together with other items I am selling, please consult with me in advance via comments. I will list them in the combination you desire. If you purchase multiple items, I will discount ¥100 per item. Please refrain from individual price reduction requests. 3D printed masking plates for RC car tires. Type: Radio Control