■ Wide-angle lens…2 (Inspected) ■ Positioning jig…2 (Yellow gauge in step 6) ■ Replacement guide…2 (Instruction manual) ※ Compatible with Panasonic doorphone VL-V571L ※ See images 2-10 for reference [Features] ・ Horizontal viewing angle of approximately 180 degrees (Reference: Image 2) ・ Feels brighter than the original (Individual perception may vary) ※ Impression when installed on VL-V571L. Performance varies depending on the usage environment. Please consider carefully. [Notes] ・ Not a genuine part; differences exist except for screw standards. ・ Disassembly and part replacement void the manufacturer's warranty. Lens replacement and use are at your own risk. ・ Not compatible with swivel models such as VL-V566 and 565. ※ Those who are overly concerned or have negative feedback are not welcome. ※ Only initial defects are covered. Please purchase only if you agree. §【Replacement Procedure】 ¶ Requires a screwdriver, precision screwdriver, pliers, and a cutter. ① Open the red circle cover and remove the screws to detach from the wall. ② Before disconnecting the wiring, turn off the power, or if working while energized, insulate each wire with tape and be careful of short circuits. ③ Remove the three red circle screws and open the back cover, referring to the images. ※ Opening it too quickly can cause wire breakage. ④ Removing the two red circle screws allows you to replace the lens, but if force is applied that bends the circuit board, the light-receiving sensor may be damaged. Remove the two blue circle screws and remove the base. ※ Check the connection of the circuit board connector. Plugging and unplugging while energized can cause malfunctions. ⑤ Unscrew the lens counterclockwise. ※ If the screw adhesive is strong, score around the screw with a cutter and turn with pliers. ⑥ Attach the base, and use the narrowest part of the positioning jig's three sides to tighten the gap between the lens and the base to a loose fit. ※ Be careful not to overtighten (damages the light-receiving sensor). Refer to Note 1 for focus adjustment. After adjustment, reassemble in reverse order. § Supplementary Note 1 From the position where the lens is attached with the jig, gradually loosen it by rotating it to the left while searching for the adjustment point. Be careful not to damage the light-receiving sensor. A subject with a clear pattern of light and dark is recommended. ※ If focus adjustment is difficult (beware of short circuits and static electricity)… Insulate the back of the lens circuit board with masking tape, etc., and connect the wiring in step 2. While looking at (or having someone look at) the screen of the sub-unit and main unit, rotate the lens to adjust. After adjustment, disconnect the connection in step 2 and reassemble. § Other Please contact us via transaction message for any questions.