Easy 1x4 Adjuster Finished Product DIY Storage Parts Set of 4, Anonymous Delivery, with Scratch Prevention Sheet For other quantities, please comment. These are DIY parts for fixing 1x4 lumber to create pillars. You don't need complicated steps or special tools just to set up the pillars. You can easily install them because they are firmly fixed using the force of a jack. Imitation and plagiarism are prohibited. The structure is different from plagiarized products. Plagiarized products do not have fixed bolts, so they lack strength. The upper part has fixed bolts, so it is stronger than plagiarized products. It is fixed in a special way and cannot be removed. Installation Method ① Cut the 1x4 lumber that will become the pillar to a height of approximately minus 80mm from the installation location (there may be slight individual differences, so measure the adjuster at its shortest length). ② Screw the lower part of the adjuster to the top of the 1x4 cut in ①. (Photo 4) ※ It is easier to insert if you use the pilot hole in the lower part as a drill guide and make a pilot hole in the pillar. Since 1x4 is thin, making a pilot hole will also prevent splitting. ③ Insert the screw side of the upper part of the adjuster into the hole in the pillar made in ②. ④ Once positioned in the installation location, stand it vertically (using a level), and tighten by turning the lower nut clockwise with a wrench. Required Tools 〇 13mm wrench or monkey wrench, etc., a tool that can turn the nut 〇 Electric drill or impact driver or Phillips screwdriver 〇 Saw (can be cut at a home center) 〇 Level (there are also apps.) Drill not required Due to being handmade, there may be some variations. Assembly is just screwing, the same as commercially available adjusters. It's a finished product, so just screw it in. Since it's 1x4, it will bend when tightened if you make a long pillar, so if you want a long pillar, 2x4 is better. For other quantities, please comment. #TwoByFour #OneByFour #WindowFrameShelf #KitchenShelf #Adjuster