This is a bracket part for attaching a commercially available 17mm ball joint compatible smartphone holder to the dashboard decoration panel of a Mazda CX-30 right-hand drive car. It is a 3D printed product using carbon fiber filled ABS resin. Smartphone holders are sold separately. The holder can be installed without any modifications such as drilling holes, as it is attached by hooking it on the top and bottom of the decoration panel. The ball joint shape is set at a height that does not obstruct the view while being slightly angled towards the driver, and in a position that does not interfere with the air conditioning vents or air conditioning controls. Metal tapping screws are used inside the ball joint for reinforcement. When installing, it is necessary to lift the decoration panel, so please prepare tools such as a clip remover. Although a cushion sheet is attached to the contact part with the decoration panel, please understand that there is a possibility of scratches, abrasions, and color transfer before use. ☆ As an example, it can be combined with the following commercially available holder ☆ Seiwa (SEIWA) MagSafe compatible wireless charging holder single item IMP302 https://www.amazon.co.jp/dp/B0D8T681XR/ In addition, there are many commercially available 17mm ball joint compatible holders, so please check your holder.