No discounts. Please read the self-introduction section. For orders of 5 or more sets, please inquire via comments. The price is 740 yen per piece. Over 10 years of sales! Tens of thousands of sets sold! Many repeat customers use these stays. 10th-anniversary improvement. The corners have been rounded to reduce the cheap look. The appearance has also become much smarter. New, 4 sets. These are general-purpose stays made of stainless steel (SUS303). Other parts are chrome-plated (hexagonal hole 4.0). Compared to similar products, the stays themselves are thinner, allowing for a smarter installation. Through repeated prototyping and testing, the thickness has been perfected. Please be careful not to scratch the license plate during installation. Stays are made to accommodate the difference in spacing between US and JP license plate holes, but due to individual differences in US frames, it may be necessary to attach the stays at an angle or slightly modify the frame. Checking the frames in stock, there are variations in the hole diameters and the spacing between holes, with differences of about 5mm. I believe there are also compatibility issues with the vehicle body. The expansion and contraction of resin and iron, and slight misalignments of the mounting hardware. It's unlikely that all vehicles will be exactly the same without any deviations. Adding the individual differences of the frames, the misalignment can become significant. About one in a thousand people get angry because the dimensions don't fit! For those people, I think the only option is to have a custom-made one made to fit their vehicle and frame. Please refrain from purchasing if you cannot tolerate a few millimeters of misalignment. The corner radius varies depending on the individual product. US license plate frames require stays for installation because the mounting holes differ from Japanese standards. * Number of sets required * 1 bolt = 1 set of stays ・Rear of regular cars (with seal) Install with 1 set and double-sided tape. ・Rear of kei cars (without seal) Install with 2 sets and double-sided tape. ・Front (for both regular and kei cars) Install with 2 sets and double-sided tape. For front and rear installation on regular cars, 3 sets are needed. For front and rear installation on kei cars, 4 sets are needed.