Three Dots Guitars S Model 3 Tone Burst Equipped with Retro Lab "Tourus Handmade pickups 1963 "Vertigo"" ■Included: ・Original arm, tremolo backplate, wrench for string height adjustment, original gig bag ・Original P.U. set and removed rear TONE pot 500kΩ ・Removed hanger & 2 screws and original nut Purchased used from a major musical instrument store in January 2023. Based on the acquisition date and the serial number, it is believed to have been manufactured around 2020. I acquired it in a state where the pickguard's protective film hadn't been peeled off, suggesting it had been used sparingly. (The film was peeled off about a year ago.) It hasn't been used much, and there are no noticeable dents, scratches, or paint chips on the headstock or the back of the neck. No rust on metal parts. No paint cracks on the neck joint. There are fine scratches from normal use, but the appearance is clean. According to a repair shop, the neck seems to have no problems, including the truss rod's remaining adjustment range. The frets seem to have about 80% remaining, based on feel. ■Setup String gauge .095-.44 / Regular tuning / String height approx. 1.5-1.8mm / Bridge is floating, 3rd string 1.5 steps UP ※MOD/Repair History (All work was done by a repair shop) ■August 2023 ・PLEK and fret leveling ・Nut replaced with TUSQ XL. ・Tremolo hanger and 2 screws (stainless steel) replaced with Wudtone (because the original hanger and screws had iron powder adhering due to friction). ■November 2024 P.U. replaced with "Tourus Handmade pickups 1963 "Vertigo" ¥17,600" (spring-mounted) ・Rear TONE pot replaced from CTS with a 500kΩ center-shaft to the same 250kΩ. ■August 2025 VOL. and F+M TONE pots (CTS center-shaft 250kΩ) were scratchy, so they were replaced. ・Vol... Replaced with COMBAT HIGHSPEEDPOT CTS CUSTOM 250KA ・F+M Tone... Replaced with the same CTS center-shaft 250kΩ #Stratocaster