Made by Mitsubishi Chemical TENSEI CK Pro Orange Hybrid 80R 350tip This is a carbon shaft for TaylorMade sleeve UT. This is a high-performance product that I adjusted for my own use. The specifications listed on the specification sheet when the club was in good condition were: Length → 40.5 inches (60° method) Frequency → 276 cpm I haven't used it much, the shaft is clean, and the grip is in good condition. There is a slight fuzziness on the grip, but overall it is in very good condition. The grip is: Elite Y360SH WO, no backline Spine alignment has been performed relative to the standard position. The spine alignment method is weight insertion, and the effects of this method are: ・The shaft runs smoothly ・Head speed increases ・Improved catch ・The shaft moves the same way every time and doesn't wobble In particular, when you waggle or move it slightly sideways, the clubs with spine alignment using this method show a beautiful reverse flex of the shaft. This doesn't happen if you haven't made any adjustments, so that's the difference, I think. The specifications are: Catalog weight → Approximately 83g Torque → 3.6° Shaft profile → Butt-end Please check the last photo for the actual measured length. No returns or exchanges. Shipping is included, and since it's a long item, the shipping cost is not cheap, and fees will be deducted from this price, so I can't lower the price any further. However, I will offer a small discount (1000 yen per additional item) if you purchase multiple items. Thank you for your consideration.