This listing is for one graver with a specific shape and size. Please note that you are selecting the shape and size, and this is not a multiple-set listing. m(__)m The main image shows examples of different shapes and sizes, including hair-line and single-cut gravers. Please refer to the illustration for the wrapped graver. This is a graver for bending into sharp curves, such as arabesque patterns. It is also suitable for half-round carving and lettering. This is a wrapped graver with a brass handle, and I have carved "New Year's Greetings" on it, so please take a look if you'd like. https://youtu.be/TSyTkhs7IQY There is also a video on YouTube of me actually carving an arabesque pattern. https://youtu.be/jMO47Hfh1ko It is also recommended as an addition to the basic 2-piece set for Japanese carving. The handle is made of SUS304 and measures 5x3x75mm. The cemented carbide tip is 25mm long, with 5mm for brazing, making the total length approximately 95mm (with individual variations). Although it is slightly thick, it is a flat square bar, so the corners are appropriately shaped. The carving is bent by the shape of the cutting edge, and the direction of the blade is carved while feeling the horizontal with the fingertips of the handle, so it is better if it is not round. The polishing of the curved cutting edge involves changing the angle, so it becomes slightly rounded. High-speed polishing of the cemented carbide boat bottom (only the rounded part is hand-polished) results in a fine, multi-faceted cut like a mirror ball, similar to diamond, so the final finish is done with diamond paste. Slightly blunting the corners with paste also improves bending. In particular, blades that are simply sharpened with a straight diamond grinding wheel, such as mass-produced products, will catch and can cause damage. If you try to carve without breaking the blade, you can only carve shallowly. It is said that you become a master when you can sharpen a graver like this, so it also serves as a sharpening example. Please refrain from purchasing if you intend to use it as a disposable tool. m(__)m When re-sharpening, it is also possible to adjust the width and angle of the cutting edge. Furthermore, the side and bottom surfaces are also finished with a single-sided mirror finish. Especially for single-cut gravers, the carving is mainly done with the corners of the side surfaces, so side surface polishing is a great advantage. However, the surface that is viewed is difficult to see, so it is not mirror-finished. *For engraving only! Requires skill in carving. Shipping method: Mercari Bin Nekopos (shipping included) http://bijodam.com/ Workshop BijoDam Graduate of the Japanese Jewelry Craft Carving and Engraving Department, CGL DC, Yutaka Ota