It's been a while since I've listed something. It's often thought that a lot of chisels are needed for Japanese tattooing, but you can usually carve most Japanese tattoo designs with just one each for hair-line carving and single-cut curves. Images 1-3 will be reused. Set Contents (excluding the scale): BijoDam Tungsten Carbide Chisel, Red Chisel Imitation, Boat Bottom Mirror Finish SPL ▲ Hair-line carving 0.7mm curve BijoDam Tungsten Carbide Chisel, SUS304 Handle, Boat Bottom Mirror Finish SPL ■ Single-cut 1.5mm curve 1 Chisel Case and 2 Rubber Caps (hair-line carving may be a little loose) As a bonus, a copper plate that I practiced on a bit, and another copper plate that can still be practiced on, 40×60×t1mm Please refer to the following individual listings for each chisel: https://jp.mercari.com/item/m99394483999 https://jp.mercari.com/item/m19770127893 As stated in the URL for the red chisel imitation, the original paint will peel off due to the heat of soldering and shaping, so it will rust during the manufacturing process, and rust converter has been applied. It will peel off with use, so a heat shrink tube will be attached. Only the bonus copper plate is used. There is also blank space, and nothing is carved on the back. If the carving on the front is bumpy, please make it a matte finish with coarse sandpaper. I have a 30-year gap in my carving, and I've only recently restarted in the last few years. It's not at the level of a model, it's just for practice. But I think the real thing will be more helpful for beginners than the images on the internet or in textbooks. Only image 4 is a real photo. Please judge whether it will be helpful from the images and videos. There are mistakes here and there. The following are 3 types of carving videos and the chisels used (all for curves): Wave and leaf pattern carving (same 2 chisels as the listing) https://youtu.be/EijrwkJv4vU Laurel wreath pattern carving (0.7▲1.5■0.5▲, a total of 3) https://youtu.be/jMO47Hfh1ko Arabesque pattern carving (0.7▲, wrapped chisel 1.0■, 1.5■, 0.5▲, a total of 4) https://youtu.be/jMO47Hfh1ko Arabesque pattern carving is difficult even with dedicated chisels. The two chisels that are often used in Japanese tattooing. After that, you can add more as you get used to carving. The recommended additions are 0.5▲ and wrapped ■ chisels. About half of the laurel wreath pattern carving has a matte finish and millwork. Matte finish and millwork require separate dedicated chisels. http://bijodam.com Workshop BijoDam, presided over by Yutaka Ota