This is a set of P-90 Pro pickups, made by Epiphone, boasting a high level of completion that follows the specifications of the legendary 1950s and 60s Gibson P-90s. There are several specifications for these pickups, and this is the type with "feet" on the baseplate. I think it can be used for large pickguard SG guitars equipped with P-90s, or for hollow-body guitars where P-90s can be mounted by hanging them from the pickup cover. As noted below, if you have a cover with a 49mm pitch, you can replace it. Current Gibson P-90s are made with a flimsy brass baseplate, and have become completely different. However, the P-90 Pro, newly created for the purpose of being installed in Epiphone guitars, is surprisingly similar to the 1950s and 60s Gibson P-90s I own. It is said that it uses Alnico 5 magnets and follows the vintage style in terms of coils, bobbins, and wiring materials. And the size between the pole pieces is also 49mm, the same as my 1950s and 60s models (both front and bridge). The lead wires are 340mm and 300mm long. The lead out was about 7.8 to 8k. Just to be sure, I'll note it again, this is the type with "feet", so it cannot be easily swapped with all existing P-90s. Especially the soapbar type. You can swap it with soapbar or dog-ear types if you cut off the "feet". Please consider this before purchasing. Also, I am listing a "no feet" version, so please take a look. Please note that the black round sticker on the back that says "Epiphone USA (+ model number)" will no longer be attached in the future.