Wheelbase approximately 73.5mm For 1/24 drift RC cars 3D printed resin comical body Printed to be mountable on the TG RACING 1/24 TT First with the TG RACING 1/24 1/28 TG First Short Wheelbase Chibi Kit combination. It may also be mountable on chassis with a wheelbase of around 73mm. Includes a full set of parts: body, hood, trunk, doors, front and rear bumpers, mirrors, light parts, windows, lenses, muffler, etc. Driver and passenger windows are not included. Doors, hood, and rear gate can be opened. The electronics are compatible with 1/24 hobby RC cars (mosquito cars). Mounting may be a bit challenging due to the short wheelbase. *Please be aware that interference may occur depending on wheel and tire size, settings, etc., so please trim as needed. Front narrow 1.5 and rear wide 3 seem to be a good fit. *As this is a resin product, shrinkage and expansion during printing have been minimized, but please adjust panel gaps yourself. *As this is a resin product, it is more fragile than plastic models, so please handle with care (especially at connection points of each part). *For clear windows and lenses, please sand with waterproof sandpaper #600-#800-#1000-#1200 until layer marks disappear, then clear coat for transparency. Please understand that due to 3D printing, they will not become perfectly clear. *Chassis, tires, and wheels shown in the images are not included. *This is a body produced with a 3D printer, so please purchase only if you understand this. *Please cut away unnecessary parts. Do not use nippers (they will break); use a small rotary tool, file, or ultrasonic cutter for cutting or sanding.