Wheelbase approximately 73.5mm For 1/24 drift RC cars 3D printed resin comical body Printed to be mountable on the TG RACING 1/24 TT First with the TG RACING 1/24 1/28 TG First Short Wheelbase Chibi Kit combination. It may also be mountable on chassis with a wheelbase of approximately 73mm. Includes a full set of parts: body, hood, trunk, doors, front and rear bumpers, mirrors, light parts, windows, lenses, muffler, etc. Driver's and passenger's side windows are not included. Doors, hood, and rear gate open and close. The electronics are compatible with 1/24 hobby RC cars (mosquito cars). Mounting may be a bit difficult due to the short wheelbase. *Please be aware that interference may occur depending on wheel and tire size, settings, etc., so please trim as needed. Front narrow 1.5 and rear wide 3 seem to be good. *As this is made of resin, shrinkage and expansion may occur during printing, although minimized. Please handle any necessary adjustments yourself. *Being made of resin, it is more prone to cracking than plastic models. Please handle with care (especially at connection points of each part). *For windows and lenses, you can make them clear by sanding with waterproof sandpaper (#600-#800-#1000-#1200) until layer marks disappear, and then applying a clear coat. Please understand that they will not be perfectly clear as they are 3D printed. *The chassis and tire/wheel shown in the images are not included. *This is a body produced with a 3D printer, so please purchase only if you understand this. *Please cut away unnecessary parts. Do not use nippers (they will crack); use a small rotary tool, file, or ultrasonic cutter to cut or sand.