Replacement Rickenbacker nameplate, aftermarket product imported from overseas. The notable feature is the embossed logo. The fact that "MADE IN U.S.A." is also embossed is a bit of a quirk... However, if you actually hold it in your hand, I think you'll be satisfied, saying, "I see." Size: 151mm x 40mm, thickness 2mm, 4mm including the embossed part. Please refer to the image for the screw hole spacing. Mounting screws are included. The last image is a scene from a Rickenbacker factory tour video. I have added an image comparing this item for sale with the item as it arrived (from another seller). There are no severe burrs from the molding runner on my item. Also, there are traces of a solvent, likely a release agent, around the screw holes, especially around the bottom two, which are difficult to remove just by wiping. My item has been carefully cleaned to remove these. Burrs, in particular, can be dangerous and may cause injury, so be careful when handling them. Furthermore, the screw holes have been expanded to make it easier to pass the included screws through. Along with this, the back of the screw holes has been chamfered to smooth them out. Take another good look at the listing images of the item you're interested in.