Handmade item made with a 3D printer. Smelt fishing bait box Ver1.1 Added magnets Counter-kun small item case set 2-tier type Size: Approximately 90mm (length) x 150mm (width) x 40mm (height) When opening and closing the bait box, it's difficult to open with one hand if it uses magnets, requiring two hands, and if left open, the maggots escape. Especially in yakatabune (covered fishing boats), it's warm, and the maggots become active and tend to escape. Therefore, I created a bait box that is magnet-free and can be easily opened and closed with one hand! Features ① By sliding the neodymium magnet to the free side, the magnet separates, allowing for easy opening and closing. It is fixed by magnets at the lock side and free side positions. ② The sliding bar acts as a stopper for the lid, stopping at a good angle. ※ It can be laid down by removing the slide bar. ③ Large finger rest makes opening and closing the lid easy. ④ The mesh size is 1.2mm x 1.5mm. ⑤ Includes one tray without holes. When using special maggots or Hon-rabi, you can shake off the sawdust and separate it into the tray. ⑥ The top of the tray has a gentle lip to prevent maggots from escaping. ⑦ The four corners inside the tray are rounded to prevent maggots from gathering in the corners and becoming difficult to remove. ⑧ There is also a recess on the lid, so it can be locked after use and stored upside down to return the sawdust. ⑨ The tray has a step so that it fits into the lid, making it difficult for sawdust to spill out during storage or when shaking. ⑩ Black color makes white and red maggots easy to see, and the maggots stand out! ⑪ The bottom of the box has non-slip silicone for grip, preventing the box from slipping. ⑫ Magnets are attached to the bottom of the box. The height is lower than the non-slip silicone, so the non-slip silicone functions properly during normal use and provides grip! If you use a magnet sheet or similar on your table, the stability will be outstanding! ※ We plan to sell tables compatible with magnets in the future. Since it is made with a 3D printer, please understand that there may be lines, burrs, unevenness, and minor scratches due to filament breaks, etc. m(_ _)m Therefore, although it is unused, I will consider it as having no noticeable scratches or dirt. We check before shipping, but if there are any scratches or malfunctions, we will exchange it. Please contact us before evaluation(^^) The color of the hinges will be silver or gold.