This is a Yanagiba knife by Minamoto Yoshimitsu. The blade length is approximately 29cm. The steel type is unknown. The handle is made of black water buffalo horn. I previously listed this item, but I sharpened and polished it again because there were some areas of concern. There is a stamp near the base of the flat blade that says "〇〇 steel," but the "〇〇" part has been erased by polishing. Since it has been mirror-polished, some small rust marks remain. I recommend it if you don't mind. The cutting edge, flat surface, and back of the blade are almost mirror-polished. It is generally clean, so I think it can be used for a long time. It has a good length and balance, and is recommended for both professional and general users. It has been finished with Kitayama 8000 grit and Shapton 12000 grit whetstones. It is in a very sharp condition and can be used immediately. ● Size: Blade length approx. 290mm ● Blade thickness: Approx. 3.3mm at the thickest part of the base of the blade ● Overall length: 440mm ● Weight: 187g #Knife #Yanagiba #Yoshimitsu #29cm