Set of 4, Tube Cutter Used This is a set of silicone tubes for replacing the feed rollers and eject rollers of Scan Snap S1500/S1500M. Silicone tube: Inner diameter 6mm, outer diameter 12mm, length approximately 24mm (may vary slightly) Tube cutter used This is for replacing the deteriorated roller rubber of ScanSnap. There are two methods: complete disassembly or partial replacement by making a vertical cut. This can be used as is for complete disassembly, or by making a cut for partial replacement. Method for complete disassembly replacement: Since it involves many steps, it cannot be fully described here. Please search online. There is no difference in normal use, and although it takes time, the appearance will be perfect. Method for partial replacement: 1. Remove the feed roller and eject roller by making a vertical cut with a cutter and pulling them off. If hydrolysis has progressed, you will need to remove the stickiness with anhydrous ethanol and cotton swabs. 2. Make a vertical cut in the new tube and set it on the shaft of the feed roller and eject roller, using the rotation of the power button. Some people use adhesive, but it is not necessary. Only those who want to can apply adhesive. This is at the level of selling the surplus purchased by an individual, so the quality is different from what companies sell. If you are concerned about burrs, please purchase those. If the quantity is insufficient, a refund will be processed.