It's often thought that a lot of chisels are needed for Japanese tattooing, but most Japanese tattoo patterns can be carved with just one each for hair-line carving and single-cut curves. Images 1-3 will be used as is. Set Contents (excluding scale) BijoDam Tungsten Carbide Chisel, Red Chisel-like, Boat-bottom Mirror Finish SPL ▲ Hair-line 0.7mm curved BijoDam Tungsten Carbide Chisel, SUS304 handle, Boat-bottom Mirror Finish SPL ■ Single-cut 1.5mm curved 1 chisel case and 2 rubber caps (hair-line chisel may be a little loose) As a bonus, I'm including a copper plate that I practiced on, and another copper plate that can still be practiced on, 40×60×t1mm Please refer to the following individual listings for each chisel: https://jp.mercari.com/item/m99394483999 https://jp.mercari.com/item/m19770127893 As stated in the URL for the red chisel-like, the original paint will peel off due to the heat of soldering and shaping, so it will rust during the manufacturing process, so rust converter has been applied. It will peel off with use, so a heat shrink tube will be attached. Only the bonus copper plate is used. There is also blank space, and nothing is carved on the back. If the carving on the front is bumpy, please make it a matte finish with coarse sandpaper. I have a 30-year gap in my carving, and I've only recently started again in the last few years. It's not at the level of a model, it's just for practice. But I think the real thing will be more helpful for beginners than the images on the internet or in textbooks. Only image 4 is a real photo. Please judge whether it will be helpful from the images and videos. There are mistakes here and there. The color may vary because oxidation is fast. The following are 3 types of carving videos and the chisels used (all for curves): Wave leaf pattern carving (same 2 chisels as the listing) https://youtu.be/EijrwkJv4vU Laurel leaf pattern carving (0.7▲1.5■0.5▲ total 3 chisels) https://youtu.be/jMO47Hfh1ko Arabesque pattern carving (0.7▲ winding chisel 1.0■1.5■0.5▲ total 4 chisels) https://youtu.be/jMO47Hfh1ko Arabesque pattern carving is difficult even with a dedicated chisel. The two chisels that are often used in Japanese tattooing. After that, you can add more as you get used to carving. Recommended additions are 0.5▲ and winding ■ chisels. Matte finish and milling are applied to about half of the laurel leaf pattern carving. Matte finish and milling require separate dedicated chisels. http://bijodam.com Workshop BijoDam Director Yutaka Ota