【Item Name】Motor Stand with Heat Sink A motor stand for breaking in mini 4WD motors (both shaft and single shaft). 【Material】Heat-resistant ABS 【Size】 Width 37mm x Depth 28mm x Height 35mm 【Contents】 Heat sink holder (3D printed) 2 copper terminals Aluminum anodized heat sink 【Features】 ・Allows the motor to be set with a heat sink to suppress heat generation during motor break-in, etc. ・Ventilation holes are also provided on the back. ・Can be used horizontally or vertically. ・The shaft area is open, making it easy to apply bearing oil. ・Space-saving, compact design. ・Can be attached from the front. ※Recommended to remove from the top. ※When using on a flat surface, customize with sponge brakes, etc., on the back. ※Fixing with a vise is also recommended. 【Notes】 ・The motor shown in the photo is not included. ・Layering marks and scratches unique to 3D printing may occur. ・The motor holder and heat sink are new, but please understand that minor scratches or dirt may be present if they do not affect use. ・Copper terminals are prone to oxidation. Discoloration may occur upon delivery, but please understand. Also, because they are cut to specified dimensions, there may be unevenness on the cut surfaces. Installation will be done with only minimal deburring. ・Since it is 3D printed, looseness may occur in the attachment depending on the number of uses. ※The holder part only will be sold separately as a consumable item at a later date. ・If there is poor contact, install the motor with the terminals on the motor side slightly raised. ※Shipping is in simple packaging to reduce shipping costs.