Thank you for viewing! This is the "Large" small item tray compatible with the [NEW] Land Cruiser Prado 150 Series (Late Model). ・【NEW!】 You can add chipping paint (black or gray) for an additional 300 yen to the product price. Please let us know in the comment section beforehand. ・You can place smartphones, HDMI devices, vehicle keys, etc. ・Can be used without interfering with the cigarette socket, HDMI, and USB ports. ・Unlike other products, it can be used without interfering with the armrest. ・There are the following four types. Please select your desired product. ① Model with two holes for the cigarette socket and HDMI port ② Model with one hole for the HDMI port ③ Flat model with no holes ④ Model with one hole for the cigarette socket ・Available in white, black, and other colors. ・As a large tray, it increases storage capacity without compromising the interior design. ・It has a lot of stability due to the three-point fixing with double-sided tape and support from two support pillars. ・There is no interference with surrounding moving parts. ・Installation is easy with only the ultra-strong double-sided tape (SCD-15) for car interiors, so no tools are required. ・All necessary parts (double-sided tape) for installation are included. ・The heat resistance of the double-sided tape is from -20 degrees to 90 degrees Celsius. ・Made of ABS resin, it is heat-resistant and can be used without problems in the car even in summer. ・The dimensions of the item placement area are 181mm long, 113mm wide, and 20mm deep for all three types. ・The load capacity is approximately 500g. ・This is not a genuine Toyota product. If you have any questions, please feel free to comment. -------------------------------------------- 【Installation Instructions】 ① Peel off the two double-sided tape films on the underside of the tray and attach them to the top of the included support pillars. ② Degrease and dry the area on the vehicle where you will be attaching the tray. ③ Peel off the remaining five double-sided tape films (3 on the sides of the tray, 2 on the bottom of the support pillars) and attach them to the position shown in the product photos. ④ After pressing firmly, leave it untouched for about 24 hours to complete! --------------------------------------------