Gray fence set for model railways, perfect for N gauge. - Type: Model railway fence - Color: Gray - Size: For N gauge Thank you for viewing. This is an N gauge size fence made with a 3D printer. The items in the first photo are all that is included. There are 6 pieces in total: 2 each of small, medium, and large sizes of rockfall prevention fences. The sizes are: length: 185-195mm, height: approximately 15-25mm, thickness: 2-3mm, and the size varies depending on the type. The material is PLA gray, and it is printed without painting. There is some stringing. It is printed with a height pitch of 0.1mm. Although unused, it is a handmade product, and there are some stringing and burrs, so it is listed as "slightly scratched or dirty." Since it is gray, it may be fine as is, but for a more realistic look, you may want to color it to your liking. Because it is thin, you can cut it with a cutter, nippers, or a router to adjust the length. Feet for installation on a diorama are attached at appropriate intervals. You can insert them by making holes in the installation location with a 1-1.5mm pin vise or a hard rod. If you don't need the feet, you can cut them off with a cutter or nippers. This is a handmade product, so please check the design carefully in the photos. Also, since it is 3D printed, please refrain from purchasing if you are concerned about burrs, stringing, steps, warping, or distortion. In particular, the back surface is flat due to the hot bed surface and does not have the same three-dimensional feel as the front surface.