・ Basically, items are shipped on the same day if payment is received by 12:00, but there may be times when we are unable to ship due to unforeseen circumstances such as sudden illness. In such cases, please request a cancellation. ・ Support information will be provided after purchase if necessary in "Mamushi's Flea Market Discussion". This is the front panel board for the EAM/ESAM1 series (ESAM03110 and others are not compatible). We will ship a board that has been tested and confirmed to be working. ※ Now, This is during the repair of a junk item that is said to be powered on. When the plug is inserted into the tap, the red light indicates that the tray is not inserted. Upon inspection, the protrusion of the drip tray is missing, possibly broken off with pliers. After replacing the drip tray, thinking it was OK, the power switch itself doesn't work at all. So, I pondered for a while. Did the seller make the drip tray unusable to clearly state that it was powered on, or are there really malicious people among flea market sellers? After that, I replaced the front panel board and was able to extract coffee, but there was severe water leakage from the generator, so the generator was replaced. ※ In conclusion, It is true that the power button may fail, as it is a frequently used switch. In such cases, the repair is completed by replacing the front panel board. However, the procedure up to this board replacement is in the category of high hurdles for DIY beginners. If you don't break the small dial claws and other accidents don't happen, you can assemble it, but the assembly has high hurdles and may not be possible with an IQ of around 100. Please be sure to confirm that all switches are functioning and have a click feel before completing the assembly, otherwise the switch will be in a state of being pressed by the cover, and the machine will not operate. Therefore, if you want to test the operation, please check whether the switches work with the board in its bare state. The subsequent assembly depends on your individual ability. I cut it off coldly, but I have included a photo of the insertion into the front panel on the third page. Push it in as is, push the dial shaft into the board side, and then press all the switches to feel the click, then screw it in, and it should be fine.