Thank you for viewing! This is a Mooer GE200. I received it used a few years ago when I was still a student, and I used it everywhere. As for its current condition: * Most of the exterior printing has peeled off, and the haphazard printing done with a permanent marker is also starting to fade. * The internal system and operation are functional. I've confirmed that it works, and it produces sound. The pedal also responds, and there seem to be no problems with its operation. * The volume knob has been replaced with something else. I believe it had the same resistance value, but it wasn't a dual-axis pot, so two were forcibly soldered on, and one of them has come off. The resistance value is 50k. So, it can be restored to its original state by attaching a dual-axis 50k pot. * Many washers are missing. Washers for the EXP terminal and R terminal, which tend to loosen, are missing. It's a halfway-there junk item that seems like it could be restored with some knowledge. You can either restore it to its original state, incorporate it into something else, or have fun changing the exterior. It comes with an adapter and a GE200-specific box. However, I don't think the accessories matter much...