Please read the self-introduction section before purchasing (❁ᴗ͈ˬᴗ͈) This is a wooden hand press using a toggle clamp, which is convenient for leathercraft. You can clamp your tools with a drill chuck. Reduces noise when using a hammer. Makes work with chisels, punches, and stamps comfortable ♪ ※The product is the one with the wood grain pattern from image 11. ※The string hardware will be red as shown in image 17. ※When using, always place the included board as shown in image 4 and use it so that the hinge does not move. ※Images 18 and 19 are reference images when using a larger die cutter currently on sale. ★Product Set Contents Wooden hand press machine (with drill chuck) Striking tools and iron plate (as shown in image 1) Opening/closing stop plate ★Size ●Height: Approximately 35.5 cm ●Width: 30 cm ●Depth: 12 cm → when stored 22 cm (when in use) ●Usable tool diameter (drill chuck) For leathercraft hand tools from 2 mm to 13 cm ※Chisels and rivet setters are not included. ●Adjust the height by placing a cutting board or rubber sheet according to the height of your tools or punches. ⚫︎When using a die cutter or punch, it is easier to make holes if you use an iron plate on the bottom. ★Precautions for use (images 19 and 20) The smooth molded plate surface of the seat If you press the deformed die cutter (③), it will be scratched. ②The flat die cutter is less likely to scratch the seat, but if it is a large flat die cutter, it is easier to use if the seat is made larger. ※When using the press, if you press something larger than the seat, or if the die cutter has a design that deforms the seat, place an acrylic plate or iron plate in between (sandwich) and enlarge the seat. #Leathercraft #Chisel #Stamp #Punch #Die cutting #Genuine leather Tools: Punch Uses: Leathercraft