EVH 5150Ⅲ 2x12 Cabinet Ivory Fully functional. When I purchased it used, the emblems on the front center and lower right were removed, and the marks were blackened out. The rear panel is missing. According to the EVH website, the dimensions are "Width x Height x Depth: 762 x 419.1 (excluding casters) x 356 mm, weight 27.22 kg." The size is almost identical, and the weight measured 23.7 kg on a scale. The speakers are two 12-inch Celestion Vintage 30s. Regarding the "3904 A" stamp on the side of the speaker: This is the official part number for the Celestion Vintage 30. • A = Variation code • VINTAGE 30 = Model name • 16Ω = Impedance • 50 10MV = Manufacturing lot code (manufactured in the 50th week of 2010) It is likely that this is from a lot that originally came with V30s (EVH used both G12H and V30 speakers depending on the time and model), or that the previous owner replaced the G12H with V30s. Visually confirmed the wiring, which is connected in parallel, resulting in a total impedance of 8Ω. Operation has been confirmed with a Marshall JCM2000, Hughes & Kettner Tube Meister 36, and Orange Dual Terror. The "NOT USE" jack on the back is an old model specification, and "NOT USE" is written on it because it is not connected to the circuit. It seems that the same panel was used for the 4x12 cabinet at the time, and it is a factory specification that leaves "terminals that are not used in that model" without being blocked, although "parts and circuit boards are shared." Therefore, as shown in the picture, it is not actually connected to the circuit, and it is a "dummy jack" that does not pass a signal even if a cable is inserted. The sound is, as expected from the Vintage 30, with a powerful mid-low range. The casters will be removed for packaging. Will ship on weekends. ⭐︎If you pick it up directly, the shipping cost will be discounted!