Thank you for viewing! ※ Basically, I don't sell color variations to avoid shipping errors. There are people selling similar items, but they are from different sellers and are different products. This product was used to create a jig that won a station challenge! This is a template for left and right independent sliding dampers. This has enough precision to be assembled as is. See the second image. It is made in a color that is easy to see when applied to carbon or FRP, making it easy to cut and mark. ※ Colors are subject to change without notice. The range of motion is theoretically 3mm. It moves quite a bit, so adjust with spacers if necessary. The third photo shows all the products. Use HG Carbon Rear Stay 3mm. See the fourth image. The seventh and eighth images are the completed diagrams. Templates for 102.5mm and 103.5mm are included. 2 is 102.5mm, and 3 is 103.5mm. See the fifth image. Use the rear brake stay. See the sixth image. The front cut position is one straight plate. Fine adjustments are needed. See images 9, 10, and 11. The pipe attached to the lid is a 2.0mm hollow propeller shaft. This needs to be bent with pliers. It's a bit difficult. For the height direction, you need the length of a straight plate and 3mm carbon. See image 12. Image 13 is an example of installation. Please make your own snag prevention stay. If you buy two items together, you get a 100 yen discount. If you buy three, you get a 200 yen discount. No other discounts are available. Please feel free to ask if you have any questions. Thank you.