True Temper Aerotech SteelFiber i95CW This is a set of 7 iron shafts. They were inserted into a set of i525 irons (7I-UW, 5 shafts) and Cleveland RTX ZIPCORE wedges (54° and 58°). They were assembled new and used for practice only twice, so some shafts haven't been hit at all. Both the shafts and grips are in very good condition. As shown in the third image, the S and X flexes of these shafts have the same weight. The difference in frequency is small in the lower numbered irons, and the flexes are sometimes mixed to adjust the frequency flow for each club. Therefore, although the base flex is S, X flex is used for some of the lower numbered clubs. The feel when hitting was exactly the same, so I think the only difference is the frequency, and there was no difference in the feel. This is a set of 7 shafts, but I can also sell 6 shafts for 33,333 yen including shipping. Please let me know in the comments if you would like to purchase 6 shafts. The club length, shaft flex, and club number when they were clubs were: 37.5 inches → S#6 (7I) 37 inches → S#7 (8I) 36.625 inches → S#8 (9I) 36 inches → S#9 (PW) 36 inches → X#9 (UW) 35.375 inches → S#W (54°) 35.25 inches → X#W (58°) These are the values listed on the workshop's spec sheet (60° method). The length may vary depending on the measurement method, head specifications, and insertion depth. Please check the last two photos for the actual length of the shafts with grips. Spine alignment has been performed, so the shaft print is not facing forward. If you align the grip logo to the front, the shaft spine will be in the adjusted position. The grips are: Elite Y360SH WO, no backline Approximately 50g / 60 caliber These are high-performance grips that I use on all clubs except the putter. They were assembled by a top-class craftsman, so I think the performance is good and the finish is neat and beautiful. No returns or exchanges. Thank you.