★ Mini 4WD MS End Bell Holder Jig (Machined from a Mini 4WD setting board.) By firmly holding the end bell holder from the outside, it protects against damage caused by irregularities. By securely fixing and reinforcing it, the motor's power is reliably transmitted to the chassis. Can be used as is. ★ Processing of A parts is required, just shave off the protrusions‼️ ★ Copies can be made with carbon slide dampers (2mm). 1.5mm carbon may be too thin to use‼️) ★ Thrust measuring instrument. Measures up to 15 degrees!! Can be folded for compact storage. ★ Enomoto Racing Shaft Checker (for hollow shafts) ★ Nut tightening tool ★ Tamiya genuine nut tightening tool (some rust) ★ MS bowing prevention plate cutting jig ★ Mini 4WD Limited Full Cowl Mini 4WD 25th Anniversary Low Friction Low Height Tires (two maroon) 2 sets ★ N03, T03 bumperless kit (without LED) ★ N04 T04 unit ★ N02 T01 reinforced unit ★ Bearing changer (for rollers 520)