This is the standard version of our workshop's original all-carbide scraper, S size. It's a palm-sized tool, smaller than general scrapers. It's used for polishing work, such as scraping off precious metals, but in the case of scrapers, it's often used for detailed work where a buff cannot reach, so we've made it smaller. The scraper is a versatile tool, and it's also highly recommended for plastic models. The tip is extremely sharp, so it can also be used for pre-engraving fine lines. We also make separate ones for extremely fine line engraving on plastic models, but it can also be used for marking on plastic models using the tip (approx. 28°). I personally make these, pursuing greater practicality, and they have a wide range of uses. It's a popular product with many comments saying it's easy to use and very useful. This is the listing for the particularly cost-effective, low-priced SSD (S size standard). Other versions are only sold on the HP. m(__)m Dimensions are approximately 3mm wide, 1.5mm thick, and 12cm long (there may be slight individual differences). Made from the highest quality domestic carbide, so there are no solder marks. Naturally, it is a purely domestic product. Notes: This is a listing for the scraper only; the items in the photos are not included (a cap is included, either transparent or black). Please note that there may be slight differences as the images and comments are quoted and reused. *The tip is extremely sharp, so it can easily chip if you bump it. Damage or chipping after use is not covered by claims. Please handle with care, including avoiding injury. We also accept re-sharpening after purchase. Delivery method is Mercari Mail Nekopos, including shipping. http://bijodam.com/ Hosted by Workshop BijoDam Graduate of the Japanese Jewelry Craft Engraving and Engraving Department, CGL DC, Yutaka Ota