SwitchBot Finger Robot Mount Base for Wall Lighting Switches 【For Bottom】 ◆ Product Overview This is a mount base exclusively for the SwitchBot Finger Robot, compatible with Panasonic Cosmo Series Wide 21 (120 x 70mm). It can be installed on the bottom of a two-row switch. ☆☆Caution☆☆ Designed based on the switch plate of Panasonic "Cosmo Series Wide 21". It is NOT compatible with square types (see photo), so please be careful not to make a mistake when purchasing. ◆ Product Contents (Assembled and shipped) Base x 1 Mount x 1 ※SwitchBot unit is not included. ◆ Material PLA resin (white) Environmentally friendly material derived from plants. ※Please use indoors as it is sensitive to high temperatures (40 degrees Celsius or higher). ◆ Installation Method 1. Combine the base and the mount and join them together. (The parts are designed to fit together) ⭐︎⭐︎Assembled and shipped⭐︎⭐︎ 2. Attach the SwitchBot unit to the mount. 3. Fit the base into the switch plate. ※Designed to be a slightly tight fit for secure fixation. 【Please Note】 ・All products are shipped after operational checks. During operation, the part that secures the SwitchBot may move slightly, but this is a design specification. If there is a problem with the operation, please contact us via comment before evaluation. We will respond quickly and sincerely. ・Due to the nature of 3D printers, there may be layer lines. ・Sanding marks may remain on the surface. ・Please refrain from purchasing if you are looking for a perfect finish or are concerned about the details. ・The product photos are reused. Please understand.