Removed from a Hustler MR31S Turbo. Selling due to vehicle sale. Everything in the photos is included. (Excerpt from the purchase site) Compatible models: Hustler MR31S R06A(TC) 14.01- Hustler MR41S R06A(TC) 15.12- Wagon R MH34S R06A(TC) 12.09-17.02 Wagon R MH44S R06A(TC) 15.08-17.02 Every DA17 R06A(TC) 15.02- Spacia Custom MK53S R06A(TC) 17.12- **Product Information:** Simply connect to the sensor to unleash potential and increase power & response!! ◯ Turbo cars → By controlling from the NA range before boost builds up, the torque connection becomes smoother, resulting in powerful torque characteristics across the entire range. 3-mode settings are pre-set, no initial setup required. Easy operation with a switch. Switch between two setting data types and normal data. For some models, simply switch between three different setting data types, so no difficult knowledge is required. Installation is secure with coupler connection. ◯ Simply connect the included dedicated installation harness to the engine room specified (air flow/pressure) sensor with a coupler, and no other connections such as power and ground are required. ◯ If you want to bring the main unit into the car, you will need a separate DCMX-E20 harness (200cm) sold separately, depending on the number of units. The MINICON main unit harness set alone is approximately 90cm. ◯ The MINICON-PRO, MAP CONTROLLER, map system 314, eco 114, and DC-SYSTEM cannot be used together because the control will overlap. The MINICONα, throttle controllers (Response Booster, Over Take Booster, TREC), ADIC, eSAVER, etc. can be used together without any problems.