This is a pre-clip tool for climbing. There are two ways to use it: ① Hanging a quickdraw with the rope already attached Hook it with the carabiner gate open, and pulling down will close the gate. ② Hanging the rope on a quickdraw that is already attached With the rope wrapped around the gate, pulling one side of the rope will push the gate open and hook it. [Tips for Use] ・When lifting, the rope may slip due to its weight, so hold the rope (both sides) together with the pole. ・When hooking onto the gate, hold one side of the rope with the pole and pull the other rope with your other hand. This product comes with a swivel mount, so it can be used with selfie sticks that don't have a swivel. It supports the standard screw (1/4 inch screw) for selfie sticks of action cameras, etc. *You can search for "1/4 selfie stick" on AMAZON, etc., and they are sold from around 1000 yen. Please select a swivel type. (A type that attaches to the tip of the PAMO brush is also sold separately) Both wire gate and key lock gate carabiners can be used. *Only the pre-clip attachment is included; quickdraws and poles are not included. It can be used without problems if the gate width is about 11-12mm, but it can also be made to fit other sizes if you wish. Since it is made with a 3D printer, please be aware that minor imperfections that do not affect functionality may be present.