Thank you for viewing. This is a jig for an AT Slide Pivot Bumper. The second image shows the product. This time, you can choose between 102.5mm (2) and 103.5mm (3), but please consider these as a guideline. The 3rd and 4th images are production samples. The carbon used is as follows: HG Carbon Front Wide Stay x 2 (glued) Rear Brake Stay x 2 HG Carbon Multi Wide Stay x 2 (glued) Straight Plate x 1 See the 5th image. The straight plate and the slightly lower part of the rear brake stay that receives the slide axis are unnecessary parts, so please cut them off at the end. These are unnecessary parts attached to the jig to make it easy to mold and fix the stays. You can assemble it as is if you don't cut those parts. There are two ways to cut: either attach the jig to the stay, mark it, and cut, or attach the jig and cut directly. See the 6th image. Finish both with a file at the end. A 100-yen store file is sufficient. See the 7th image. The slide body and the two pivot arm parts need to be glued together, so use instant glue to adhere them firmly. For the moving parts, use eyelets or flanged brass spacers as you like. I mainly shorten them and attach them to the body. It can be used without them. The cutting position on the chassis is one straight plate's worth. See the 8th image. Depending on the chassis, it may be necessary to flatten the tapered part. Since it is compatible with the separately sold left and right independent slide dampers, you can easily replace them by simply swapping the units. See the 10th image. If you buy it together, you get a 100 yen discount. Please take a look at my other listings! Feel free to ask if you have any questions.