◆ Product Description ◆ ○ Homemade low-temperature solder, no rosin ○ High-purity 99% bismuth, tin, and lead alloy. ○ Thin and easy to use! Perfect for removing small electronic components ♪ ○ 10g is the perfect amount for those who only want to use a little. 30g and 100g are for those who want to use a lot, such as for repairs. ・ Melting point around 97 degrees Celsius ・ Length approximately 10cm - 15cm ・ Weight approximately 3.5 - 5g per piece ・ Diameter approximately 2mm, cylindrical ※ There are variations in length and weight. ◆ How to Use ◆ ○ Apply solder to cover the legs of the board components and heat evenly to remove them. The remaining solder can be removed with flux and desoldering braid. ◆ Examples of Board Component Removal ◆ ・ USB connector ・ Controller analog stick board ・ Mouse microswitch ・ Potentiometer Can also be used to remove multi-pin IC components and other components. ※ Approximately 5g of solder can remove 2-4 of the above components. ◆ Caution ◆ ○ Regarding the photos, the solder has been melted in hot water and formed into droplets. It has not been melted by contact with a hot iron plate. ○ Lead, which is used in common eutectic solder to lower the melting point, is included. ※ Mercury and cadmium are not included. Please handle with care. ○ Since this is a transaction where you cannot confirm the actual condition of the product, please read the images and description carefully and make your decision before purchasing. ◆ Shipping Method ◆ ○ Yu-packet Post ○ We will ship within the shipping period (1-2 days), but please understand that it may be delayed due to work circumstances. ps4 ps5 pc switch xbox USB computer mouse Joystick analog Junk repair electronic components Solder Dalcé alloy lead bismuth