Thank you for viewing! This is "innermountain GUITAR and miscellaneous," and I am selling items I have made personally. I have a small number of other items for sale, so please click on the seller's name to see the list of items. This product is a wooden backplate set for a PRS SE Custom 24. The set includes one plate for the control cavity where the volume and tone pots are stored, and one plate for the tremolo unit. Please consider this for dressing up your guitar or replacing the original plastic backplates due to aging. 【Product Details】 The wood is walnut. It has figure that appears due to differences in growth rate during the growth process, and the grain shimmers like quilted maple. The finish is an oil finish using Xotic Oil Gel. Due to the characteristics of Xotic Oil Gel, a film is formed even with an oil finish, resulting in a glossy finish. The control cavity of the PRS SE is treated with conductive treatment, so an aluminum seal is attached, similar to the original plastic backplate. The thickness is approximately 2mm, the same as the original plastic. Please check the 10th photo for product size. I have measured as accurately as possible, but there may be some errors due to being handmade. Please understand. Wood hardener is used as a measure to prevent warping and cracking. However, because it is made of wood, please be aware that warping or cracking may occur due to strong screw tightening, impact, or changes in humidity. Please be especially careful when tightening the screws during installation. As shown in the photos, I have confirmed the installation on the guitar body. Please note that mounting screws are not included. 【Management Number: BK-131225】