【This product is made to order】 Estimated delivery: Scheduled to ship on 10/24 ※Shipping may be slightly delayed. 【Item Name】Motor Stand with Heat Sink A motor stand for breaking in mini 4WD motors (both shaft and single shaft). 【Material】Heat-resistant ABS 【Size】 Width 37mm × Depth 28mm × Height 35mm 【Contents】 Heat sink holder (3D printed) 2 copper terminals Aluminum anodized heat sink 【Features】 ・Allows the motor to be set with a heat sink to reduce heat generation during motor break-in, etc. ・Ventilation holes are also provided on the back. ・Can be used horizontally or vertically ・The shaft area is open, making it easy to apply bearing oil ・Space-saving, compact design ・Can be attached from the front. ※Recommended to remove from the top ※When using on a floor, customize with sponge brakes, etc., on the back. ※Clamping with a vise is also recommended. 【Notes】 ・The motor shown in the photo is not included. ・Layering marks and scratches unique to 3D printers may occur. ・The motor holder and heat sink are new, but please understand that there may be minor scratches or dirt if they do not affect use. ・Copper terminals are prone to oxidation. There may be discoloration upon delivery, but please understand. Also, because they are cut to specified dimensions, there may be unevenness on the cut surfaces. They will be installed with only minimal deburring. ・Since they are 3D printed, the fit may loosen depending on the number of uses. ※The holder part only will be sold separately as a consumable item at a later date. ・If there is a contact failure, install the motor with the terminals on the motor side slightly raised. ※Shipping will be in simple packaging to reduce shipping costs.