Original design that holds the new Freed's instrument panel in three places. This is a 3D printed ball mount. The ball diameter is 17mm, a size used in many commercially available smartphone holders. Please use it in combination with your existing holder or a commercially available product. Currently, only the mount is sold because the product price increases with a magnetic head. ***About Types (See the comparison front view)*** type2 (Product photo) This is the standard type with a ball placed in the center of the instrument panel, providing ample space for the navigation screen. This is recommended for those whose smartphone cases or holders are 70mm or wider. type1 This is the type used by the creator, who combines a 9-inch navigation system with an iPhone SE2. The ball is positioned 12mm to the left of type2 to avoid interfering with the operation of the navigation system on the right and to keep the smartphone from overlapping the steering wheel as much as possible. type0 At the request of the buyer, the ball is positioned 10mm further to the left than type2 (22mm to the left of type2). This is because they wanted the smartphone screen to be positioned as far away from the steering wheel as possible, even if it overlapped the navigation screen. If you want a type other than type2 (standard), please specify the type in the comments or in the transaction message after purchase. We will also try to accommodate those who want a ball diameter other than 17mm as much as possible after consultation. The material is PBT with glass fiber, which I chose because I felt it had a good balance of toughness, flexibility, heat resistance, chemical resistance, and texture. This holder mount is attached and held by the toughness and flexibility of the material, and some play and twisting will occur even after installation. When removing the smartphone, please remove it while lightly holding the holder. ******About the heat of the sunlight***** Although it is made of a material with a heat resistance of around 70°C, the strong sunlight in summer can reach that temperature inside the car and on the dashboard depending on the situation. For example, when parking in the open air, please take measures such as removing the holder and smartphone and blocking direct sunlight to reduce the load. The product is unused, but please understand that it is a 3D print using the FMD method by an individual before purchasing.