【※Plate not included.】 This is an assembly for a Precision Bass. Recommended for those who want to upgrade their current bass! 『Assembly Introduction』 【Pots】 Entry-level basses often have plates with metric hole standards. I considered CTS pots, which are known for their quality, but CTS pots use inch standards and are not compatible. Therefore, I chose Alpha pots, which are metric and of good quality. They are 250kΩ, a good value for basses. You can install them directly on your plate. This time, I made them with full-size pots. 【Jack】 I use a Japanese-made jack. The quality is quite good, and I feel it's not much different from Switchcraft. 【Wiring】 The wiring uses cross-wire, which is also used in Fender and other high-end guitars. It has a good stiffness and is durable. ※The cross-wire will be either skin-colored or yellow. It is usually skin-colored, but it may be yellow. Please understand that there is no change in function. 【Capacitor】 The capacitor is the classic Orange Drop. Specs → 200v 0.047uf This is the most common value used for basses. The tone works well and is very easy to use. As you can see, I have put a lot of effort into the quality. Please feel free to upgrade. ※Specifications may change irregularly. This is for quality improvement, so please rest assured that it will never change for the worse. Please refer to photos 3 and 4 for pickup wiring methods and pot dimensions. You will need a soldering iron to wire it. Soldering irons are sold at 100-yen shops for about 500 yen. Power-on confirmation has been completed. Shipping will be via Yu-Yu Mercari Mail in an A4-size brown envelope. If you are concerned about wire breakage, I can send it via Yu-Packet Plus for an additional 200 yen. I have kept the price down as much as possible, so I cannot lower the price any further. #Bass