⭐︎ Recreating the v3 type with a Bright Cut switch Thank you for viewing. Low price and high quality handmade effectors are the strengths of leakpedal. This product is made with PtoP wiring and is completely hand-wired. * A technique that does not use pre-wired printed circuit boards, but wires components together by hand. ■ Product Name leakpedal MG-1 This is a clone pedal that recreates the JHS Pedals Morning Glory, developed based on the legendary Marshall Blues Breaker, with hand wiring. Although the amount of distortion is small, it is characterized by a natural distortion, and it is finished as a pedal that delicately follows the player's picking nuances. The Bright Cut switch on the front of the enclosure allows for a slightly subdued sound with reduced highs. ■ Components For the capacitors that affect sound quality, we use Japanese electrolytic capacitors and AVX film capacitors, which are often seen in boutique pedals. The LM833N is used for the IC, which is the heart of the sound. ■ Specifications ・112(D) x 60(W) x 31(H)mm (excluding protrusions) ・Operating voltage 9~18V ・Center minus AC adapter drive *9V battery cannot be installed. ・Controls: Volume (top left) / Drive (top right) / Tone (bottom right) ・Toggle switch: Bright Cut *ON to the right. ・LED Blue ・True bypass ・PtoP wiring ■ Thoughts I carefully select parts, layout, make the board, and assemble everything. Please try the highest quality/sound quality all-handmade pedal. ■ Warranty Initial defects that occur within one week of receipt will be repaired free of charge. We will also provide thorough support for any failures that occur after that.