This is a bracket for relocating the surplus genuine front speakers to the rear. ・Set of left and right ・With bolts ・Designed for easy installation with a single Phillips screwdriver ・No wiring modifications needed as the connectors are the same for the rear ●Material PLA+ ※Higher strength, rigidity, impact resistance, and heat resistance than PLA ※No worries about moisture absorption like MDF ●Fixing screws Tapping screws ※Low risk of loosening because they tighten while cutting female threads ※Nuts are not used. If nuts are used, the fastening may loosen due to resin creep, and there is a possibility of falling off due to vibration. ●Installation procedure ① Screw the speaker to the bracket ※3 small included bolts each ② Remove the cable hook on the vehicle side indicated by the red circle in the 5th photo (Pinch both sides and push in) ③ Attach the speaker connector ※No wiring modifications needed as the rear uses the same connector as the front ※If the connector wiring doesn't reach, cut the tape bundling the cables as shown in the 7th photo and pull them out ④ Screw the bracket with the speaker attached to the vehicle and return the cable hook ※It is easier to set by setting it sideways as shown in the 5th photo and rotating it 90 degrees ※4 large included bolts each Speakers are not included. Thank you.