◆ Product Description ◆ ○ Homemade low-temperature solder, no rosin ○ High-purity 99% bismuth, tin, and lead alloy. ○ Thin and easy to use! Perfect for removing small electronic components♪ ○ 10g is the perfect amount for those who want to use just a little. 30g and 100g are for those who want to use a lot, such as for repairs. ・ Melting point around 97 degrees Celsius ・ Length approximately 10cm - 15cm ・ Weight approximately 3.5 - 5g per piece ・ Diameter approximately 2mm, cylindrical ※ There are variations in length and weight. ◆ How to Use ◆ ○ Apply solder to cover the legs of the board components and heat evenly to remove them. The remaining solder can be removed with flux and desoldering braid. ◆ Examples of Board Component Removal ◆ ・ USB connector ・ Controller analog stick board ・ Mouse microswitch ・ Potentiometer Can also be used to remove multi-pin IC components and other components. ※ Approximately 5g of solder can remove 2-4 of the above components. ◆ Caution ◆ ○ The photo shows the solder after it has been melted in hot water and formed into droplets. It has not been melted by contact with a hot iron plate. ○ Lead, which is used in common eutectic solder to lower the melting point, is included. ※ Mercury and cadmium are not included. Please handle with care. ○ Since this transaction does not allow you to confirm the actual condition of the product, please review the images and description carefully before making a purchase. ◆ Shipping Method ◆ ○ Yu-packet Post ○ We will ship within the shipping period (1-2 days), but please understand that there may be delays due to work. ps4 ps5 pc switch xbox USB computer mouse Joystick analog Junk repair electronic components Solder Dalce alloy lead bismuth