Thank you for viewing! (o´∀｀o) For custom orders, I offer disaster hood covers (for chairs, shoulder type) for 3730 yen, but this one was made freely, so it's cheaper than a custom order(^^) It's a shoulder type, so you can use it in various ways (∩´∀｀)∩ Lining is included in all of them⭐️ However, if it gets too thick, it becomes difficult to sew, and there's a possibility of breaking the sewing machine, so I used a thin fabric(^ー^) Shoulder types are especially difficult to sew, and there may be slippage or distortion. Please understand that this is amateur handmade❕(;＞_＜;) For the part that goes over the chair, I used "quilted" fabric only for this part because I was a little worried about the strength with thin fabric(o´∀｀o) I don't think you'll be able to find anything like this anywhere else❗️ I put two Velcro fasteners on the part where you put the disaster hood in and out(^ー^) These are attached in a cross shape, so you don't need to check the location of the Velcro fasteners, and it's easy to use( ´ー`) Depending on the disaster hood, the thickness and size may vary, but by attaching the Velcro fasteners in a cross shape, I think it will be somewhat flexible( ´ー`) I also have Velcro fasteners on the part that goes over the chair(^ー^) These are attached horizontally(^ー^) I put them on the side so they wouldn't slip⭐ Size is as follows↓ Length approx. 35 cm x Width approx. 50.5 cm Because I am an amateur, there may be slippage distortion asymmetry and so on. Even so, I thought about the construction and made it this way without any decorations so that you can use it for as long as possible m(_ _)m If you are looking for something like a store-bought item, please refrain from purchasing. Type...Disaster hood cover 258